Maintenance, Cleaning; Tips And Tricks - Metabo BS 14.4 LTX Impuls Mode D'emploi

= Impact drilling
Note: Always work at high speeds
when impact drilling.
= Normal drilling without impact
7.8 Activating the pulse function
(depending on the model)
Do not work for long periods with pulse func-
tion switched on! (The motor can overheat.)
Press the button (11)
the pulse function.
The button (11) flashes when the pulse function is
active.
Note: If the machine is not used for approx.
5 minutes, the pulse function switches off auto-
matically and the flashing button (11) goes out.
7.9 On/Off switch, setting the speed
Switching on, speed: press the trigger (13). The
rotational speed can be changed at the
trigger switch by pressing.
Switching off: Release the trigger (13). Note: The
noise that the machine makes when it
switches off is due to the design (quick stop)
and has no influence on the function or the
service life of the machine.
7.10 LED lights
For working on dimly lit areas. The LED lights (12)
light up when the machine is switched on.
7.11 Opening, tensioning the keyless chuck
AUF, RELEASE
GRIP, ZU
Opening the chuck
Turn sleeve (2) in the direction "AUF,
RELEASE".
The grating sound which may be heard after
opening the drill chuck is functional and is
stopped by turning the sleeve (2) in the oppo-
site direction.
Clamping the tool
- Open the keyless chuck and insert the tool as far
as possible.
to activate or deactivate
2
- Turn sleeve (2) in direction "GRIP, ZU" until the
noticeable mechanical resistance has been over-
come.
- Caution! The tool is not yet clamped! Keep
turning the sleeve (it must "click" when turning)
until it cannot be turned any further - only now is
the tool securely clamped.
7.12 Chuck with Quick replacement
system (for BS 18 LTX Quick)
To remove: Push the interlock ring forward (a),
advance and pull off the chuck (b).
To mount: Push the interlock ring forward and move
the chuck as far as the limit stop on the drill spindle.
7.13 Unscrewing the chuck
(for BS 14.4 LTX Impuls, BS 18 LTX,
BS 18 LTX Impuls, SB 14.4 LTX Impuls,
SB 18 LTX, SB 18 LTX Impuls)
c 2
- Open the keyless chuck.
- Slacken the screw (a) (note: left-handed thread!).
- Lock the spindle using a spanner (c) and
unscrew the keyless chuck (2) using spanner (b).
Employ the same procedure when attaching the
chuck, except in reverse order.

8 Maintenance, cleaning

From time to time, hold the machine vertically with
the chuck facing downwards and turn the sleeve
fully in the direction "GRIP, ZU" and then turn fully
in the direction "AUF, RELEASE". The dust
collected falls from the keyless chuck.

9 Tips and Tricks

Drilling
ENGLISH
ENG
a
b
b a
9