Working Without Depth Stop; Tips And Tricks; Troubleshooting; Maintenance - Metabo SE 4000 Mode D'emploi

ENG ENGLISH
screws): the surface area of the screw head is 2
mm outside the stop sleeve (9).
b) Flat head screws: The surface area of the screw
head is 2 mm outside the stop sleeve (9).
Insert a screw as a test. Correct the insertion depth
if necessary: When the depth stop (6) is inserted,
the insertion depth changes by 0.25 mm per notch.
If screw insertion has to be deeper: Insert stop
sleeve If the screw insertion is too deep: Unscrew
stop sleeve.
Removal of the depth stop (6) does not alter the set
screw insertion depth. After refitting, work can
continue at the same insertion depth.
When screwing in crosshead screws, press
the machine with the screwdriver bit firmly
against the screw until the screw is fully
inserted; otherwise the bit could slip out of the
cross recess and damage the material.
If the machine is not held exactly vertical in relation
to the tool, the depth stop counterbalances this (to
a certain extent).
7.5

Working without depth stop

Adapt the speed of the screwing process by care-
fully pressing in the trigger switch.
When the screwing process is complete, switch off
the machine by releasing the trigger switch (2).

8 Tips and Tricks

Press the machine firmly against the screw until
the screwing process is complete.
This is particularly important when inserting dry
wall screws (with coarse threads) in gypsum plas-
terboards because the large thread pitch of the
screws means that they are very quickly inserted.
If the stop sleeve (9) is stiff, it can be removed to
clean the thread.
.

9 Troubleshooting

If the screwdriver bit is too tightly fitted in the tool-
holder, pull the screwdriver bit out with pliers or
push the quick-change lock (8) to the rear with the
help of the depth stop. See the chapter on Tool
change
ENG

10 Maintenance

Disconnect the mains plug before starting any
maintenance work.
Motor cleaning: blow out the machine regularly
through the rear air slots with compressed air.
8
If the long hole in the quick-change lock (8) is
contaminated, clean it and blow out with
compressed air. Pour some oil into the long hole if
necessary.
Remove the depth stop (6) regularly and clean it
f

11 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Screwdriver bits (length: 25 mm)
Recommendation: only use screwdriving bits
with insertions like this:
B Scaffold hook with integrated bit depot
For complete range of accessories, see
www.metabo.com or the main catalogue.

12 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
The connection cable must only be replaced by
Metabo or an authorised customer service work-
shop.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

13 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.