Manual Storing Of Station Presets; Automatic Memory Of Station Presets; Tuning To Preset Stations - Alpine CDM-7857RB Mode D'emploi

Masquer les pouces Voir aussi pour CDM-7857RB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Manual Storing of Station Presets

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Make sure that the F button lights red, then
press and hold any one of the preset buttons
(1 through 6) for at least 2 seconds until the
station frequency on the display blinks.
3
Press the Preset button into which you wish to
store the station while the frequency display is
blinking (within 5 seconds).
The display stops blinking once the station has
been memorized. The display shows the band,
preset No. with a triangle (9) and station
frequency memorized.
4
Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply
select the band desired and repeat the
procedure.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
MW and LW).
NOTE
If you store a station in a preset memory which already
has a station, the current station will be cleared and
replaced with the new station.
Automatic Memory of Station
Presets
1
Press the BAND button repeatedly until the
desired radio band is displayed.
Each press changes the band:
→ FM1 → FM2 → MW → LW
2
Press and hold the A.ME button for at least 2
seconds.
The tuner will automatically seek and store 6
strong stations in the selected band in order of
signal strength.
The frequency on the display continues to
change while the automatic memory is in
progress.
When the automatic memory has been
completed, the tuner goes to the station stored
in the preset location No. 1.
NOTE
If no stations are stored, the tuner will return to the
original station you were listening to before the auto
memory procedure began.

Tuning to Preset Stations

1
Press the BAND button repeatedly until the
desired band is displayed.
Each press changes the band:
→ FM1 → FM2 → MW → LW
2
Make sure that the F button lights red, then
press the station preset button that has your
desired radio station in memory.
The display shows the band, preset number with
a triangle and frequency of the station selected.
7
-EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cde-7855rbCde-7854rmCde-7854rCde-7853r

Table des Matières