Auto Shut-Off; Dynamic Weighing - OHAUS SD Serie Manuel D'instructions

SD SERIES BENCH SCALE

Auto Shut-Off

•
after approximately four minutes of inactivity. This feature is only active
during battery operation.

Dynamic Weighing

1. With platform empty, press the UNITS
indicator • flashes next to the desired measuring unit.
2. Place a mass on the platform. The scale will show "-A-".
NOTE: If using a container, press ON/ZERO
weight and return to zero.
3. With a mass on the platform or container, a short press of
Cal
UNITS will start the averaging countdown from 5
seconds.
4. The averaged weight is then displayed. The indicator •
stops flashing when the process is complete.
5. The display will hold until a button is pressed.
6. To repeat the process, press UNITS
the platform or container.
7. To Exit, remove the mass from the platform or container
and press UNITS
: To extend battery life, the scale will automatically turn off
Cal
.
Cal
button until the
Off
to tare the
Cal
with a mass on
EN-7