Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; First Time Installation - Tucson TL5005SMART Mode D'emploi

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.
To Switch the TV Off
Press the " " button on the remote control or press and
hold the control switch on the TV until the TV shuts
down, so the TV will switch to standby mode.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or " " button to highlight the required
language, press OK button to select. "First Time Installation"
appears. Use " " or " " button to set the required country,
and press " " button to select Search Type. Use " " or "
" to set the desired search type. Available search types are
Digital and analog, digital only and analog only. When set,
press " " to select Teletext Language. Use " " or " " button
to set the "Teletext Language" and select "Scan Encrypted"
using " " or " " button. You can set Scan Encrypted as
Yes if you want to scan coded stations.
(*) IMPORTANT: When you select Country option as
France or Italy, you will be asked to set and confirm
a PIN number. Selected PIN number cannot be 0000.
Enter a PIN number and confirm it by entering once
more. Press OK button to continue. If the two PIN
numbers match, your master PIN number will be set.
WARNING: When you are required to enter a PIN
number for any menu operation you should use the
PIN that you have previously defined during the first
time installation. If you have forgotten the PIN number
English - 42 -