Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
DESCRIPTION
Fig. 1
1. Safety catch
2. Slide
3. Cartridge haft
4. Switch
APPLICATION
Fig. 2
The tacker enables you to fasten various materials, such
as fabric, wood, gauze, cardboard and leather. There-
fore, the tool is suitable to upholster furniture, to wrap
objects or to repair shoes.
For this tool, use one of the following types staples or nails:
•
U: 6, 8, 10, 12, 13 or 14 mm
•
T: 14 mm
•
I: 14 mm
Suitable staples and nails are provided by Esco, Rapid,
Novus and Wolfcraft.
4
LOADING THE TACKER
Before opening the tool, make sure the tool is dis-
connected.
TO LOAD THE TACKER
Fig. 3 - 5
Unlocking slide
1. Turn the metal rear plate of the slide to unlock the
slide.
Placing staples
2. Remove the slide from the tool.
3. Place the staples or nails in the cartridge
Placing nails
4. Replace the slide in the tool.
5. Lock the slide by fastening the metal rear plate.
USING THE TACKER
Fig. 6 - 8
Placing the tool
1. Place the tool with point A at the spot where the sta-
ple or nail should be located.
2. Press the tool down firmly.
Pressing safety catch
3. Press the safety catch and hold it in this position.
Stapling
4. Press the switch.
The tool will cause a rebound because of the force it
operates with. Keep this in mind.
TROUBLESHOOTING
In case of malfunction, disconnect the tool immedi-
ately.
In case a staple or nail is jammed in the tool, fol-
low the procedure below
1. Disconnect the tool.
2. Carefully remove the staple or nail from the tool with
a thin object (for example a knife).
Ferm
Ferm
45
Publicité
Table des Matières
