Enodis MENUKEY2 Notice D'utilisation page 5

INSTALLATION
Remove packing material and protective film from the oven.
Check for obvious signs of transit damage. If necessary, inform the
supplier IMMEDIATELY.
LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers, grills, griddles, etc.
A heat barrier to the height of the oven must be installed if sited next to a
hob, stove or range.
Note the minimum recommended
clearance required for air flow
50
50
485
492
592
50
410
460
Microcook HD1025
& HDV1025 Model
Place the oven on a flat surface that is LEVEL, STRONG and STABLE.
Allow a minimum clearance of 50mm to the rear, top and each side to
allow air to circulate freely.
The air intake is located under each side and to the rear of the oven, even
with the clearance specified above it is important that airflow is as cool as
possible and not pre heated by other appliances such as fryers, grills or
griddles.
Allow a minimum of 50mm clearance above the oven for hot air to escape.
Allow sufficient clearance for the door to open fully upwards.
Do not affix labels/stickers to oven other than those applied by the
manufacturer
50 50
50
535 485
Gastronorm HD2025
Door removal
clearance
50
Door open
clearance
472
522
5
50
535
647
747
Door removal
clearance
Door open
clearance
Note:
The air intake is located
under each side of the oven
and to the rear, even with the
clearance specified below
it is important that airflow
is as cool as possible and
not pre-heated by other
appliances such as fryers,
grills and griddles as this
will deteriorate the life and
performance of the oven.
100
Note the minimum
recommended clearance
required for air flow
WARNING:
Check that the
AIR FILTERS are in place
prior to operation
( see Main Features )