Sony VPLL-ZM100 Manuel D'installation page 16

Replacing the lens
5
Remove the two screws (3 x 8mm) and the four clamps
that hold circuit board C in place.
Lift up circuit board C and remove the three connectors
joined to circuit boards Q and B below.
Circuit board C
Clamps
Connectors
6
Remove the four screws (4 x 12 mm) that hold the lens in
place and remove the lens from the front of the projector.
16
7
With the VPLL-ZM100 replacement lens label facing
upwards, align the painted white mark (
with the white mark (
lens.
Secure the lens with the four screws (4 x 12 mm).
Clamp
) on the lens
) on the projector and insert the