To Start The Product - Husqvarna DM 230 Manuel D'utilisation

5. Cut a hole in the sealing disc in the nearest smaller
dimension as the core drill.
6. Connect the slurry collector/wet dust extractor to the
connection of the slurry ring.
7. Put the slurry ring on the drill spindle (C).
C
8. Install the drill bit to the drill spindle (D).
9. Start the slurry collector/wet dust extractor.
1473 - 001 - 04.04.2022
D
10. Lift the drill bit to the ceiling. Attach the slurry ring to
the ceiling.
To decrease the temperature of the
motor
• Operate the product with no load for 2 minutes to
decrease the temperature of the motor.
To change gear
CAUTION:
motor decreases in speed or stops. Do not
use force to change gear.
• Use the applicable speed for the drill bit diameter.
Refer to the rating plate on the product or
data on page 20 .
• Turn the drill spindle and at the same time turn the
gear selector to change gear.

To start the product

WARNING:
can rotate freely. The drill bit starts to rotate
when the motor starts.
Change gear only when the
Technical
Make sure that the drill bit
13