Revell Control TECHNIK RC TRUCK X-RANGER Mode D'emploi page 15

The remote control of the vehicle switches on automatically when the joystick is
actuated. To switch on the model, set the switch 1D on the underside of the
vehicle to ON 4A. The ON/OFF switch 1D on the model must be set to OFF after use.
Otherwise, a drive command can accidentally be triggered, causing the vehicle to
drive away on its own, which can lead to considerable damage.
The correct trim is a basic requirement for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it requires a little patience and a feel for it.
Please follow the following instructions precisely:
If the vehicle pulls to the left or right while driving without steering...
use the straight-ahead trimming 1E to correct the wheel alignment by turning it
in the opposite direction. The wheel alignment can be found on the bottom of the
vehicle (cf. 5).
6A In order to drive forwards, push the lever for forward and reverse travel 2A
on the left side of the remote control forwards.
6B In order to drive backwards, push the lever for forward and reverse travel 2A
on the left side of the remote control backwards.
6C To drive along a left curve, press the right steering lever 2D on the remote
control to the left.
6D To drive along a right curve, push the right steering lever 2D on the remote
control to the right.
4 START PREPARATION
5 STEERING TRIM ADJUSTMENT
6 VEHICLE CONTROL
15