Preparatory Steps; Installation Layout - V2 ELETTRONICA CALYPSO Instructions D'emploi Et D'installation

CALYPSO actuator
Blinker
Aerial
Key or digital selector

PREPARATORY STEPS

The new series of actuadors CALYPSO, has been devised to serve gates up to 500 Kg with leaf up to 3 meters wide (look at the table
technical data). Before proceeding with the installation, please make sure that your gate opens and closes freely, and that:
• Hinges and pins are in optimum condition and properly greased.
• No obstacles are within the moving area.
• There is no friction with the ground or between the leaves.
• Your gate shall be equipped with central

INSTALLATION LAYOUT

cable 4 x 1 mm 2
cable 2 x 1,5 mm 2
cable RG-58
cable 2 x 1 mm 2
and side stops, which are fundamental for the good system operation.
Internal photocells
External photocells
Control unit
9
2
cable 4 x 1 mm (RX)
cable 2 x 1 mm 2 (TX)
cable 4 x 1 mm 2 (RX)
cable 2 x 1 mm 2 (TX)
cable 3 x 1,5 mm 2