Before Use; Using The Product - LIVARNO LUX 288689 Instructions D'utilisation Et Consignes De Sécurité

Prevent fire and
injury hazards
RISK OF BURNS! Ensure that the product has
been switched off and has cooled before touching
it, to avoid burn injuries.
CAUTION! RISK OF FIRE! Never expose the
magnifier to direct sunlight or other light sources.
Never leave an open magnifier unattended. Doing
so presents a fire hazard due to bundled light rays and con-
centrated heat.
The product may only be used with the built- in LED control gear.
The LEDs are not replaceable.
If the LEDs fail at the end of their lives, the entire product must
be replaced.
The product continues to draw a small amount of power even
if the product is off as long as product is connected to supply
mains. To switch the product off completely, the mains switch
should be switched off.
Please note the product is not dimmable.

Before use

Note: Remove all packaging materials from the product.
Insert the screw clamp
the screw clamp
screw (Fig. B).
3
Now place the screw clamp
ness and secure the screw clamp
clockwise (Fig. C).
Insert the articulated arm
and secure by tightening the wing bolt
1
Verify the articulated arm

Using the product

Plug the mains plug of the product into a properly installed
socket.
Move the ON / OFF switch
product on.
8 GB/IE/NI
into the bracket
2
into the bracket
2
onto a table top ≤ 6 cm in thick-
2
into the round hole on the bracket
4
is firmly tightened in the bracket
4
into the I position to switch the
9
(Fig. A). Secure
1
using the locking
1
by turning the screw
2
clockwise (Fig. D).
6
.
1