Before Use; Using The Magnifier - LIVARNO LUX 101449-14-01 Instructions D'utilisation Et Consignes De Sécurité

101449_livx_LED-Lupenleuchte_Content_BE_NL.indd 7
CAUTION! RISK OF FIRE! Never expose the
magnifier to direct sunlight or other light sources.
Never leave an open magnifier unattended. Doing
so presents a fire hazard due to bundled light rays and con-
centrated heat.

Before use

Insert the screw clamp into the bracket
screw clamp into the bracket using the lock screw
Now place the screw clamp onto a table top ≤ 6 cm in thickness
and secure the screw clamp by turning the screw clockwise
(Fig. C).
Insert the articulated arm
and secure by tightening the wing bolt
Verify the articulated arm is firmly tightened in the bracket.
Using the LED magnifier light
Plug the mains plug of the light into a properly installed socket.
Move the ON / OFF switch
light on.
Move the ON / OFF switch into the 0 position to switch the
light off.
Adjusting the LED magnifier light
Never use force when adjusting the light.
The light can be adjusted in different ways:
· The lamp head is pivot-mounted inside the ball joint
· After loosening the lock screw
head up or down. Tighten the lock screw after adjusting the
light to the desired position.
· The individual parts of the articulated arm
by the joints .
4

Using the magnifier

Lift the cover to use the magnifier.
10
Focus the object you wish to view by changing the distance to the
object and the distance between your eyes and the magnifier.
(Fig. A). Secure the
1
into the round hole on the bracket
7
clockwise (Fig. D).
5
into the I position to switch the
9
you can adjust the lamp
6
7
(Fig. B).
3
(Fig. F).
8
can be moved
GB/IE 7
18.08.14 10:31