Airzone Jump Kids AirZone Manuel D'utilisation page 8

WARNING:
!
CHOKING HAZARD - Small Parts
Not for children under 3 yrs.
Bottom of enclosure pole that goes
into socket on frame.
18
Insert the smaller diameter end of an upper
enclosure pole into the larger diameter end
of a lower enclosure pole and align screw
holes. (You may need to slide the pre-
installed foam sleeves to gain access to the
ends of the poles)
21
Insert screw & tighten. DO NOT OVER-
TIGHTEN!. Repeat step 20 with the remaining
5 enclosure pole assemblies.
Upper
24
Locate the upper and lower sets of hook and loop
fasteners sewn to the enclosure mesh There are 6
upper and 6 lower sets of hook & loop fasteners.
TRAMPOLINE & ENCLOSURE ASSEMBLY
Refer to PARTS LIST for identi cation of parts.
19
Insert screw & tighten. DO NOT OVER-
TIGHTEN!. Repeat steps 18 to assemble
remaining 5 sets of upper & lower poles.
22
Locate the 6 nylon patches with grommets
that are sewn onto the top edge of the mesh.
Select a nylon patch that aligns with a pole.
Carefully slip one of the patches over the top
of the enclosure pole so that the grommet is
aligned with the screw hole in the pole. Use
care so that you do not tear the mesh.
Lower
! WARNING:
ADULT ASSEMBLY REQUIRED
Contains small parts, sharp points and sharp edges.
_ ç í í ç ã
b å Ç
20
23
25
Tightly wrap both the upper & lower hook and loop
fasteners around the enclosure pole foam to secure
the mesh in place. Repeat this with the remaining
upper and lower hook & loop fasteners on the other
5 enclosure poles.
7
_ ä ~ å â = c ç ~ ã
Insert the bottom end of enclosure pole
assembly into the socket on frame, as
shown. Align screw holes.
Insert screw & tighten. DO NOT OVER-
TIGHTEN!. Repeat this setp with the remaining
5 patches and poles. When done properly,
the enclosure mesh will be hanging on the
INSIDE of the enclosure poles. The mesh
should hang down somewhat straight and
not 'twist'
q ç é
b å Ç
Top é
^ á ê ò ç å É =
b ã Ä ç ë ë É Ç
cç ~ ã