Airzone Jump Kids AirZone Manuel D'utilisation page 7

WARNING:
!
CHOKING HAZARD - Small Parts
Not for children under 3 yrs.
8
Lay out the jump mat in the center of the frame with
the enclosure mesh facing up. Then slide a suspension
cord from left to right through the nylon loop you
picked in step 7, as shown. (When securing the
cords always position your left hand under, and right
hand over, the frame.)
11
Enclosu re pole
socket
14
Lay the pad cover, AirZone printed side up,
over the suspension cords. Carefully position
each of the 6 openings in the pad cover over their
corresponding enclosure pole sockets, as shown.
16
Align the grommet attached to the bottom of the lower mesh skirt with the
hole near the base of the leg and secure with screw. DO NOT OVER-TIGHTEN.
TRAMPOLINE & ENCLOSURE ASSEMBLY
Refer to PART S LIST for identification of parts.
Use your right hand to stretch the 'loop' end
9
of the cord OVER the top rail and your left
hand to pull the 'knob' end of the cord UNDER
the top rail, then pass the knob through the
loop.
2
1
12
Next, count back around the jump mat 8 loops
0
and repeat steps 8-10 attaching the 3rd cord
about half way between the 1st & 2nd cords.
15
Carefully work the lower mesh skirt (attached to the pad cover)
down, around the entire perimeter of the trampoline, on the outside of the legs.
! WARNING:
NEVER ALL
TO USE OR JUMP ON THE
TRAMPOLINE WITHOUT
THE ENCLOSURE
PROPERLY
AND INSTALLED
WARNING:
!
ADULT ASSEMBLY REQUIRED
Contains small parts, sharp points and sharp edges.
3
2
2
13
0
OW
A CHILD
ASSEMBLED
17
Repeat Step 16 with the remaining 5 grommets in the
lower mesh skirt and their corresponding legs.
6
10
3
5
1
8
4
Then, from the 3rd attached cord, count
around the jump mat 15 loops and repeat
steps 8-10 0 to attach the 4th cord. Numbers
0
on the picture above show the approximate
positions of the first 8 suspension cords.
Continue connecting the remaining cords
as shown in steps 8-1 , but always connect
0
a cord, and then switch to the opposite
side of the trampoline to connect the
next cord. Attaching the cords in this
manner is important, as it will ensure
even-tension around the entire jump mat.
As you work, keep the enclosure mesh
gathered to the center of the mat.
7
2
6