Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3-29010 CD1000 US 05.11.29 5:29 PM ページ8
System connection e
System connection e
• • Never cut the insulation on the power wire or use it to power any other equipment. If the rated current
capacity of the power wire is exceeded, fire and electric shocks may result.
• • The wires should be secured with tape or a similar securing method to prevent any obstructions while
driving. If they get wound or entangled around components such as the steering wheel, shifting lever,
or brake pedal, accidents may result.
• • If removing the end of the wire to connect to another wire, be sure to wrap PVC tape or a similar wire
insulating method around the connection to insulate it. If the connection is not insulated, fire or
accidents may result.
Tip
• • Install and connect all of the peripheral equipment before connecting them to the main unit.
• • Do not remove any of the protective caps (RCA, etc.) unless in use.
• • Be sure to wrap the connection wires with tape (PVC tape) to insulate them.
• • Adjust the external amplifier's input level.
■
CD1000 Main unit, used alone
ANTENNA PLUG
TO BATTERY+12V (Permanent Supply)
TO TURN-ON WIRE OF EXTERNAL EQIPMENT
TO POWER ANTENNA RELAY (Supply)
Red
TO ACC (Power Supply)
Yellow
Blue/White
(Supply)
OR
Pink
TEL MUTE
Black
TO GROUND
2
INTERCONNECTING WIRES
(Power and speaker connector)
xample
xample
1
MAIN UNIT
16P
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
- 8 -
FRONT SPEAKERS
REAR SPEAKERS
Publicité
Table des Matières
