Milwaukee 6390-20 Manuel De L'utilisateur page 6

4. To install a blade, place the blade on
the spindle with the teeth pointing in
the same direction as the arrow on the
lower guard (Fig. 4). Release the lower
guard lever.
Fig. 4
5. Place the outer blade flange on the
spindle and hand tighten the bolt. Larger
diameter of outer fl ange (Fig. 3) should
rest on blade.
6. While holding the spindle lock button in,
use the wrench to turn the bolt clockwise
and tighten.
Adjusting Depth
1. Unplug tool.
2. To adjust the depth of the cut, hold the
saw by the Tilt-Lok™ handle and loosen
the depth adjusting lever by lifting it up
and away from the shoe (Fig. 5).
Fig. 5
3. Raise or lower the shoe to the desired
position. Markings in 1/4" increments are
located on the inner side of the upper
guard for depth setting. For the proper
depth setting, the blade should extend
no more than 1/4" below the material
being cut (Fig. 6).
4. Move the depth adjusting lever towards
the shoe and push down to secure the
position.
10
Adjusting Bevel Angle
1. Unplug tool.
2. To adjust the angle of the cut, hold the
saw by the Tilt-Lok™ handle and loosen
the bevel adjusting lever by lifting it up
towards the blade (Fig. 7).
Fig. 7
3. Hold the front handle and rotate
the saw by the Tilt-Lok™ handle
to the desired angle as indicated
by the markings on the bevel scale
(Fig. 8).
Fig. 8
4. Move the bevel adjusting lever away
from the blade and push down to secure
the position.
Adjusting Tilt-Lok™ Handle Angle
This circular saw is equipped with an adjust-
able handle. The Tilt-Lok™ feature allows
the user to adjust the angle of the handle for
optimum cutting positions.
1. Unplug tool.
2. Press in and hold the handle lever re-
lease button.
3. Loosen the handle release lever by lift-
ing it up and away from the Tilt-Lok™
handle (Fig. 9).
Fig. 9
4. To adjust the handle position, hold the
front handle and rotate the Tilt-Lok™
handle to the desired angle as indicated
by the handle rotation adjustment mark-
ings (Fig. 10). The Tilt-Lok™ feature has
eight (8) detents which allow the handle
to snap into position. Allow the detent to
snap into place.
Fig. 10
NOTE: The blade depth setting will
determine the range of Tilt-Lok™ posi-
tions available for the application. See
"Adjusting Depth" for instructions on
adjusting the blade depth.
11