afriso KSG mini Notice Technique page 24

5 Mounting
Only mount the product after having completed all pipe assembly work, all
welding work and all soldering work.
1. Flush the lines of the system before installing the product.
If you install the product in an existing system, observe the information in
chapter "Retrofitting the product" on page 11.
5.1 Preparing mounting
 Verify that the nominal pressure of the product corresponds to the speci-
fication value of the system.
 Verify that the liquid in the system and the application area of the product
are compatible.
 Verify that the product cannot be shut off.
- Do not install shut-off valves, filters or similar equipment.
 Verify that the product is mounted in such a way that no external forces
can act on the components after it has been installed.
5.2 Mounting the product
Mounting
KSG mini
EN
7