Exit Wireless Setup; Customize Thermostat (Installer Setup) - Honeywell RedLINK Manuel D'installation

RedLINK™ Installation Guide (EIM)
4

Exit wireless setup

Press at the EIM to exit wireless setup (light should stop flashing).
CONNECT
Note: The EIM will automatically exit wireless setup after 15 minutes of inactivity.
Note: If installing more than one thermostat and EIM, you must exit wireless setup before
installing an additional thermostat and EIM.
5

Customize thermostat (installer setup)

Follow the steps below to begin installer setup. At each function screen,
▲ ▼
press or to change the setting as desired, then press
the next function screen.
See tables on pages 9-11 for a description of options for each function.
FAN
To begin, press and hold the
until the display changes (about 3 seconds).
Function Setting
1
Done Back
Press DONE to save & exit.
and ▲ buttons
FAN
0
Next
8
NEXT
0
Done Back
Press ▲ or ▼ to change setting
(see tables on pages 9-11)
Press to display next
NEXT
function screen
to advance to
0
Next