Daikin VRV FXUQ18PVJU Mode D'emploi page 6

1. Open the suction grille.
Simultaneously and slowly slide the two knobs down the
suction grille.
Knob
2. Take out the air filter.
Carry out the work in the order mentioned below.
1 Pull the air filter end inclined downward and unhook the
hooking hole of the air filter from the projection of the
grille. (both right and left)
2 Lift the air filter and unhook the hooking hole of the air
filter from the projection at the grille upper part. (both
left and right)
2
Filter
1 1
1
Projection
Filter
Air filter end
3. Clean the filter.
Clean the contamination with a vacuum cleaner or wash it
with water.
If the air filter
is extremely
contaminated,
wash it with
neutral detergent
using a soft brush.
NOTE
• Do not wash the air filter with water of 122°F (50°C) or
higher.
It may cause decolorization and deformation.
• Do not heat the filter with fire.
It may cause burning.
2
Knob
2
Grille upper
part projection
2
Filter
After dewatering,
dry the air filter in
the shade.
4. Attach the air filter.
Attach the air filter in the reverse order mentioned in the
clause 2 (page 2).
5. Close the suction grille.
Simultaneously slide the two knobs, slowly lift the suction
grille and securely fix it in the reverse order mentioned in
the clause 1 (page 2).
6. Turn off the indication "
displayed on the remote controller after turning on
the power.
• For details, refer to the operation manual attached to
the remote controller.
The indication can be turned off whether in operation or
at stop.
NOTE
• When closing the suction grille, the strap is likely to be
sandwiched.
Make sure the strap is not sticking out before you close
the suction grille.
Strap
HOW TO CLEAN THE SUCTION GRILLE
1. Open the suction grille.
Simultaneously and slowly slide the two knobs down the
suction grille.
Knob
" or "Time to clean filter"
Suction grille
Knob
3P338599-13E English