Eagle Group HT Serie Manuel D'utilisation Et Instructions page 3

djustable Undershelf
assembled BEFORE securing legs to table.
*
igure 1
1. Place table on top with gussets facing up.
Caution: Use cardboard or other material to prevent scratching top.
2. Install legs into gussets. Make sure rivet in leg is closer to gusset
than to the foot end.
3. lign undershelf gussets with legs, and slide undershelf down legs to
desired position. Do not force or beat corners as damage could occur.
4. Tighten set screws* in undershelf gussets to secure undershelf
(see igure 1) and install feet into legs, using a rubber mallet.
5. Tighten set screws* in gussets to secure legs to table.
6. Place table on back with control knobs up.
7. See applicable cutting board mounting instructions below.
* To be compliant with NS guidelines, either the supplied NS set screw
caps (see illustration below) must be installed over all exposed set screws,
or exposed set screws must be filled with silicone sealant.
set screw
Cutting Board with
Stationary Brackets
acorn
nut
mounting
bracket
washer
hex bolt
1. ttach mounting brackets to support shelf,
using acorn nuts, washers, bolts and
predrilled holes. Note: acorn nuts must be
at the top.
2. Install machine screws into threaded
fasteners on hot food table. Do not tighten.
3. lign keyholes in mounting brackets with
screws and mount support shelf/bracket
assembly to table. Tighten screws.
4. lign holes in cutting board with acorn
nuts, and place cutting board onto
support shelf.
SSEMBLY INSTRUCTIONS
NOTE: Legs and undershelf must be
NSF set screw cap
Cutting Board with
Optional Drop Brackets
drop
bracket
cutting board
assembly
drop bracket
machine screws
to screw
into unit
1. Mount drop brackets to table, using
machine screws and threaded
fasteners on table.
2. Mount cutting board assembly to
drop brackets on table.
3. Raise cutting board up until it is in
horizontal position and slide toward
hot table.
Bolted Undershelf (optional)
igure 1
1. Place hot table on top with gussets facing up.
Caution:Use cardboard or other material to prevent scratching top.
2. Install legs into gussets.
3. Mount undershelf to legs by inserting bolt thru hole in leg and thru hole
in corner of undershelf and tighten with hex nut (see igure 1).
4. Tighten set screws in gussets to secure legs.
5. Place hot food table on back with control knobs up.
6. See applicable cutting board mounting instructions below.
Cutting Board with
Optional Plate Shelf
acorn
nut
support
shelf
bracket
washer
hex bolt
channel
(inside
cutting
1. ttach shelf support brackets to support shelf,
board
assembly)
using acorn nuts, washers, bolts and
predrilled holes. Note: acorn nuts must be
at the top.
2. Install machine screws into threaded fasteners
on hot food table. Do not tighten.
3. lign keyholes in mounting brackets with
screws and mount support shelf/bracket
assembly to table. Tighten screws.
4. Hook metal plate shelf into bottom flange of
plate shelf brackets.
5. Using keyholes on support shelf brackets,
mount plate shelf/bracket assembly onto
support shelf/bracket assembly.
6. lign holes in cutting board with acorn nuts,
and place cutting board onto support shelf.
NOTE: Legs and undershelf must be
assembled BEFORE securing legs to table.
plate shelf
bracket