Troubleshooting - Fellowes AeraMax DX5 Mode D'emploi

4. Place the new filters in the main unit.
(True HEPA Filter should always be
inserted first, then the Carbon Filter)
5. To reset the filter light once a new True
HEPA and/or Carbon Filter is installed:
a. Be sure that back panel is snapped
in place.
b. Turn on the unit.
c. Locate the filter replacement icon on
the display panel.
d. Press and hold the filter replacement
icon for 3 seconds until unit beeps.
HEPA Filter icon will flash amber.
Press filter icon area to alternate
between HEPA and Carbon.
e. Once desired filter is illuminated,
press and hold for 3-5 seconds. A
short beep will be heard and the light
should turn off. Repeat process for
each filter as needed.
AeraMax-DX5_870323_RevB_3L_032117.indd 10-11
10 10

TROUBLESHOOTING

Before you call
Solutions to Common Problems
Review this list before you call for service. This list covers problems that are not the result
of defective materials or workmanship.
PROBLEM POSSIBLE SOLUTION
The unit leaves smoke • Make sure the sensor is not blocked or clogged.
• Move the unit closer to the offending odors.
and odors in the air.
• Replace the filters as needed.
• Replace the filters as needed.
The unit seems to
produce odors.
The unit makes a faint • This indicates that the PlasmaTRUE
ticking sound.
The unit interferes • Because this unit radiates radio frequency energy, we suggest
you try one or more of the following:
with radio or television
reception. - For better reception, adjust the television/radio antenna.
- Move the unit away from the affected television/radio.
- Plug the unit power cord into an outlet different from the
television/radio power cord.
The True HEPA • Repeat filter light reset instructions from page 10.
and Carbon Filter
indicators remain lit
after replacing the True
HEPA and/or Carbon
Filter.
• Touch and hold PlasmaTRUE™ icon for five seconds until
The PlasmaTRUE™
icon is not illuminated. unit beeps.
The wrong filter • In the case of unintended filter reset, repeat the filter reset
replacement light was procedure on page 10 within 5 minutes of unintended reset.
reset. • The filter counter and indicator will return to the status
previous to the reset.
function is working.
TM
11
4/21/17 10:07 AM