On/Off Switch - Emglo E810-4V Guide D'utilisation

Improperly locked handle or
improperly secured cargo
on top of wheeled dolly can
shift, causing loss of control
and causing personal injury or
property damage.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
FEATURES (Fig. 1)
knoW youR AIR CoMpRESSoR
READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE
OPERATING YOUR UNIT. Compare the illustrations with your
unit to familiarize yourself with the location of various controls
and adjustments. Save this manual for future reference.

on/off SWITCH

Place this switch (A) in the ON position to
provide automatic power to the pres-
sure switch and OFF to remove power
at the end of each use.
pRESSuRE SWITCH
The pressure switch (J) automatically
starts the motor when the air tank pres-
sure drops below the factory set cut-in pressure. It stops the
motor when the air tank pressure reaches the factory set cut-
out pressure.
pRESSuRE RELEASE VALVE
The pressure release valve located on the side of the pressure
switch, is designed to automatically release compressed air
Extend handle fully and lock
handle in place and secure
cargo on top panel with
retention straps before moving
compressor.
A
from the compressor head and the outlet tube when the air
compressor reaches cut-out pressure or is shut off. The pres-
sure release valve allows the motor to restart freely. When the
motor stops running, air will be heard escaping from this valve
for a few seconds. No air should be heard leaking when the
motor is running or after the unit reaches cut-out pressure.
SAfETy VALVE
If the pressure switch does not shut off
the air compressor at its cut-out pressure
setting, the safety valve (G) will protect
against high pressure by popping out at
its factory set pressure (slightly higher than the pressure switch
cut-out setting).
CHECk VALVE
When the air compressor is operating, the check
valve (F) is open, allowing compressed air to
enter the air tank. When the air compressor
reaches cut-out pressure, the check valve
closes, allowing air pressure to remain inside
the air tank.
QuICk-ConnECT BoDy: The quick connect body accepts
J
industrial quick connect plugs. The two quick connect bodies
allow the use of two tools at the same time.
CooLInG SySTEM (noT SHoWn): This compressor contains
an advanced design cooling system. At the heart of this cooling
system is an engineered fan. It is perfectly normal for this fan to
blow air through the vent holes in large amounts. You know that
the cooling system is working when air is being expelled.
TAnk pRESSuRE GAuGE
The tank pressure gauge (B) indicates
the reserve air pressure in the tank.
11
G
F