R-Go HE Sport Manuel page 20

transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Conformément à la réglementation d'Industrie
Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou
inférieur) approuvé pour l'émetteur par Industrie Ca-
nada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il
faut choisir le type d'antenne et son gain de sorte que
la puissance isotrope rayonnée équivalente (p.i.r.e.) ne
dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
This equipment complies with the ICES RF radiation
exposure limits set forth for an uncontrolled en-
vironment. This equipment should be installed and
operated with a minimum distance of 20cm between
the radiator and any part of the human body.
Cet équipement est conforme aux limites d'exposition
aux radiations ICES définies pour un environnement
non contrôlé . Cet équipement doit être installé et
utilisé à une distance minimale de 20 cm entre le
radiateur et une partie de votre corps.
FCC REGULATORY STATEMENTS (only for wireless
mouse version)
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions.
1) This device may not cause harmful interference.
2) This device must accept any interference received,
including interference that may cause undesired
operation.
20
Warning: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate this
equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment
and receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV
technician for help.
This equipment has been verified to comply with the
limits for a class B computing device, pursuant to
FCC Rules. In order to maintain compliance with FCC
regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment
or unshielded cables is likely to result in interference
to radio and TV reception. The user is cautioned that
changes and modifications made to the equipment
without the approval of manufacturer could void the