Carrier RG67G/BGEF Manuel Du Propriétaire page 11

Press this button under COOL Mode to enter the energy efficient mode.
X-ECO
Note:This function is only available under COOL mode for heat pump air conditioner only.
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature automatically to 24 °C/75 °F,
fan speed of Auto to save energy (only when the set temperature Ois less than 24 °C/75 °F). If the set temperature
is above 24 °C/75 °F, press the X-ECO button, the fan speed will change to Auto, the set temperature will remain
unchanged.
X-ECO
Note:
Pressing the X-ECO button, or modifying the mode or adjusting the set temperature to less Othan 24 °C/75 °F will
stop ECO operation.
Under ECO operation, the set tmeperature should be 24 °C/75 °F or above, it may result inO insufficient cooling. If
you feel uncomfortable, just press the X-ECO button again to stop it.
GEAR operation:
Press the X-ECO button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption)
↓
50%(up to 50% electrial energy consumption)
↓
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternage between electical energy consumption and
set temperature.
Press X-ECO button to enter the energy efficient mode in a sequence of following:
ECO → GEAR(75%) → GEAR(50%) → Previous setting mode → ECO......
10