Klarstein VALERIA Mode D'emploi page 27

Activated carbon filter
1 Before installing the activated carbon filter, first remove the grease filter. Press the
lock and remove the grease filter.
2 Slide the activated carbon filter into the rectangular hole below the engine until it
clicks into place at the rear of the rectangular hole. Raise the two fixing rails until
they are horizontally above the carbon filter.
3 Then reinsert the grease filter.
4 To remove the activated carbon filter, proceed in reverse order.
Replacing the bulb
How to replace the bulb:
5 Switch the unit off and pull out the plug first.
6 Wait until the light bulb is cooled down before
replacement.
7 Take out the baffle filter and use the screw driver to
take out the frame (see pic).
8 Replace with same type of bulb.
EN
27