Metal Rack; Electrical Connection - CASO DESIGN HCMG 25 Mode D'emploi Original

Assemble the glass turntable as follows:
 Insert the rolling ring
 Place the glass turntable inside the appliance so that the grooves on the underside of
the glass dish lock into the turntable drive.
 Never place the glass tray inside the appliance upside down; it must be able to revolve
freely.
 When cooking always use the glass turntable and the matching rolling ring.
 Always place all food and containers on the glass turntable or the grating for grilling.
 In case the glass turntable or the rolling ring crack or break please contact your Service
Centre.
13.6.2
 Place the metal rack on the glass turntable.
► Use the metal rack only for grilling, convection and combination operation C3.

13.7 Electrical connection

DANGER
► Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the appliance.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not
properly installed and grounded.
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
 This appliance must be electrically grounded. In case of a short circuit grounding will
protect against electric shocks because the electrical current is diverted through the
grounding lead. The appliance is fitted with an appropriate cable with a ground lead
and a grounded safety plug. The plug must be inserted into a properly installed and
grounded outlet.

Metal rack

60