Safety Notes - Dentsply Sirona ProMix 2 Mode D'emploi

2

Safety notes

Be aware of the following general safety notes and the special safety notes in other
chapters of these Instructions for Use.
Safety alert symbol.
•
•
2.1 Precautions
Dual voltage: The capsule mixer operates on voltages between 120 and 240 V, 0.5 A
-0.3 A, 50 and 60 Hz, for compatibility with multiple power voltages and frequencies.
This capsule mixer is designed to be safe under the following conditions:
• Indoor use where no pollution or only dry, non-conductive pollution occurs.
• Altitude up to 2,000 metres (6562 ft) and temperatures from 5 °C (41 ºF) to 40 °C
(104 ºF).
• Maximum relative humidity 80% for temperatures up to 31 °C (87.8 ºF) decreasing
linearly to 50% relative humidity at 40 °C (104 ºF).
• Mains voltage supply fluctuations up to ± 10% of the nominal voltage and transient
over voltages typically present on the mains supply.
• This capsule mixer is designed for the mixing of encapsulated dental restorative
materials only. No other, in particular hazardous, materials should be used on this
equipment.
• This unit will not automatically re-start in the event of a power failure.
• The capsule mixer is designed for intermittent use. Maximum continuous duty cycle
is 30 operations of 8 seconds per hour.
• Always make sure the unit is placed offside the dental unit and only touched with
clean/disinfected gloves to prevent from exposure to spatter or spray of body fluids.
Electrical short-circuit or dangerous malfunction.
Injury.
1. Safeguard unit against ingress of liquids.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible
injury.
3