Carl Valentin DUOPRINT Mode D'emploi page 107

Key:
Printhead temperature
Key:
Printhead 2 Offset
Key:
Motor Ramp
Key:
Input
Key:
Output
Key:
I/O status
Key:
Online/Offline
Key:
Zero point adjustment
in Y direction
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the printer display.
The printhead temperature is displayed for both printheads.
For setting the automatic offset for the rear printhead in order to optimise the print image..
X-adjustment: Adjusting the position of the print image of the rear printhead (colour
component) transversely to the direction of paper movement..
Y-adjustment: Adjusting the position of the print image of the rear printhead in the direction of
paper movement.
Any changes to these parameters alter the relative orientation of the print contents of the front
and rear printheads.
This function is often used for high printing speed as the tearing of transfer ribbon can be
prevented.
The higher the '++' value is set, the slower the feeding motor is accelerated.
The smaller the '− −' value is set, the faster the feeding motor is decelerated.
Indication of input signal level.
0 = Low
1 = High
Indication of input output level
0 = Low
1 = High
Relevant results are counted and registered in RAM memory. The protocole get lost after
switching off the device.
RInt = Real Interrupts
The start input impulses are counted directly at the Interrupt.
Dbnc = Debounced
The start input impulses that are longer than the set debounce time are counted. Only these
start impulses can lead to a print. If a start impulse is too short, no print is released. This is
recognized by the fact that RInt is counted, Dbnc not.
NPrn = Not Printed
The debounced start input impulses that have not lead to a print are counted. Causes: no active
print order, print order stopped (manually or because of an error) or the printing system ist still
active with the processing of a print order.
PrtStrtReset = The counters are reset.
PrtStrtTime = Measured length of the last start impulse in ms.
This function is activated e.g. if the transfer ribbon is to be changed. It is avoided that a print
order is processed although the module is not ready. If the function is activated then press the
key to change between Online and Offline mode. The respective state is indicated in the
display (Standard: Off).
Online: Data can be received by interface. The keys of the foil keyboard are only active, if you
changed in the Offline mode with key
Offline: The keys of the foil keyboard are still active but received data are not processed. If the
module is again in Online mode then new print orders can be again received.
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the same position on the label,
the difference can be corrected in printing direction.
NOTICE!
The value for zero point adjustment is set ex works. After replacing the printhead,
only service personnel are allowed to set this value anew.
.
English
DuoPrint
107