AVIRE Memcom+ Guide D'installation page 9

Full Programming Options
Menu Sections
System Config+
Auto Location
x ü
Avoid Silence x ü
Quick Dial
x ü
Quick VAD. ü
x
Dialtone req x ü
Lineflt. Alert ü
x
Hotline
x ü
Hardware (HW) Monitoring
Hardware monitoring sets which system elements are checked when
the unit completes its self-check and places a test call. Default
settings are shown below:
Power Supply
ü
Battery
ü
Phone Line
ü
GSM low sig. û
GSM no sig. û
Spkr/mic.
ü
GSM Status û
When an operator answers an alarm call, the Memcom
automatically play the location message.
NOTE: when programming in the alarm numbers
'UNGUIDED' protocol must be selected (see section on Alarm
Numbers for more detail).
During an alarm call the Memcom will not mute its speaker,
+
unless the operator presses the '2' key on their handset.
Reduces the dial tone detection test from 7 seconds to 3
seconds – prevents issues with exchanges timing out after 4
seconds.
Allows the Memcom + to detect speech before the first ring
pulse has been sent down the line.
Requires the Memcom to detect a dial tone before it attempts
+
to dial out.
If the phone line to the Memcom + is cut, the unit will play an
audible warning message. The message will repeat every 3
minutes unit the phone line is restored.
Tells the Memcom it is connected to a hotline, allowing any
other of the call protocols to then be selected for use on that
line.
+ will
9 9