ETA Systems PCI-065NA Guide De L'utilisateur page 2

ENGLISH INTRODUCTION
ESPAÑOL
FRANÇAIS
Thank you for your purchase of this power
DEUTSCH conditioning solution. Our broad family of power
conditioning products is designed to protect
ITALIANO
sensitive electronic systems from the destruction,
degradation, and disruption caused by electrical
power disturbances.
The model you have purchased is designed
for use with a wide variety of electronic systems
including terminals, workstations, LAN servers,
telecommunications KEY and PBX systems, point
of sale systems, medical instrumentation, audio
and video systems, and many others.
INSPECTION
Remove the power conditioner from the
shipping container and inspect it for shipping
damage. Do not install or operate the product if it
appears to be damaged in any way. If damaged,
notify the carrier and the company that sold it to
you immediately.
ENVIRONMENTAL ISSUES
This power conditioner has environmental
requirements similar to other computer and electronic
equipment. It has been designed for indoor use only,
in areas where it will not be exposed to excessive
dust or moisture. Make certain that there is adequate
airflow around the unit. Do not place objects on top
of or near the unit, which could obstruct the air vents.
SIZING INFORMATION
The data plate on the rear panel lists the power
conditioner operating voltage, frequency, and current
ratings. Observe that the input current rating is not
exceeded when connecting single and multiple loads
to the power conditioner receptacles.
WARNING: TO PREVENT
ELECTRICAL SHOCK, DO NOT
REMOVE THE POWER
CONDITIONER COVER.
INSTALLATION
Install the power conditioner as close as
possible to the load equipment. Do not use
extension cords or surge or filtration devices with the
power conditioner.
Place all load equipment power switches in the
off position. Plug the power conditioner into an
appropriately sized AC power source.
Plug the load equipment into the power
conditioner receptacles. The load equipment must
be connected to the power conditioner with a three
conductor grounded power cord.
If in doubt about how to properly connect this
power conditioner, please consult the connection
diagram shown at the end of this section.
ATTENTION: The power
conditioner's "green screw" ground-
stud is to be used to connect items
such as static discharge floor mats
or telephone switch grounds that
contain a single conductor ground.
Any equipment that is not connected
via a 3-conductor grounded power
cord will be floating above ground.
If the end user elects to provide
additional grounds, they must be
tied to the thumb screw ground-stud.
Turn the power conditioner circuit breaker ON.
Observe that the front-panel green LED is
illuminated. Observe that the red LED (yellow for
international models) is not illuminated. (Place the
power conditioner on a non-grounded surface such
as carpet, wooden table or magazine for this test).
ENGLISH
ESPAÑOL
FRANÇAIS
DEUTSCH
ITALIANO