General Description; Front Panel Description - KPS -PA10 Manuel D'instructions

KPS-PA10 • Digital clamp meter
potential. Keep your body isolated from ground by using dry clothing; rubber
shoes, rubber mat, or any approved insulating material.
• You always are careful when working with voltages above 60V dc or 30V ac
rms. Keep fingers behind the probe barriers while measuring.
• Never use the meter to measure voltages that might exceed the maximum
allowable input value of any function.
• Never touch exposed wiring, connections or any live circuit when attempting
to take measurements.
4. MAINTENANCE
• Before opening the case, always disconnect test leads from all energized
circuits.
• Never use the meter unless the back cover is in place and fastened
completely.
• Do not use abrasives or solvents on the meter. To clean it using a damp cloth
and mild detergent only.
• Qualified and trained service technicians should only perform calibration and
repair of the meter.
• Do not attempt calibration or service unless trained and another person
capable of rendering first aid and resuscitation is present
5.

GENERAL DESCRIPTION

The meter is a handheld 3 1/2 digital clamp meter for measuring DC and
AC voltage, AC current, Resistance, Diode and Continuity Test with battery
operated.
6.

FRONT PANEL DESCRIPTION

1 Transformer jaws. Pick up the AC current flowing through the conductor.
2 Hold button. When this button is pushed, the display will keep the last
reading and "H" symbol will appear on the LCD until pushing it again.
3 Rotary switch. This switch is used to select functions and desired ranges.
4 Back light. To use this function, press the LIGHT button. When this button
is pushed, the Back light of display is on. After about 3 - 5 seconds, the Back
light is self-off. The Back light is on again, just push this button once.
5 Display. 3 1/2 digit, 7 segment, 16mm high, LCD.
6 "V" jack. This is positive input terminal for VOLT measurements connection
is made to it using the red test lead.
11