Operating Procedures - MAT Industries Powermate Vx SAC22HPP Manuel Du Propriétaire

Compresseur d'air de 7,6 litres
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DAILY STARTUP
1.
Set the Auto/Off switch to the Off position. (A)
2.
Inspect the air compressor, air hose, and any accessories/tools being used
for damage or obstruction. If any of these mentioned items are in need
of repair/replacement, contact your local authorized dealer before use.
3.
Close the drain valve. (B)
4.
Connect the air hose to the quick connect socket on the regulator assembly
by inserting the quick connect plug on the air hose into the quick connect
socket. The quick connect socket collar will snap forward and lock the
plug into place providing an air tight seal between the socket and plug. To
release the air hose push the collar back on the quick connect socket. (C)
5.
Plug the power cord into the proper receptacle. (D)
6.
Set the Auto/Off switch to the Auto position and the compressor will start
and build air pressure in the tank to cut-out pressure and then shut
off automatically. (A)
7.
Adjust the regulator to a PSI setting that is needed for your application and
be sure it is within the safety standards required to perform the task. If using
a pneumatic tool, the manufacturer should have recommendations in
the manual for that particular tool on operating PSI settings. (E)
Figure 4
D
SHUTDOWN
(Figure 4)
1.
Set the Auto/Off switch to the Off position. (A)
2.
Unplug the power cord from the receptacle. (D)
3.
Set the outlet pressure to zero on the regulator. (E)
4.
Remove any air tools or accessories.
5.
Open the drain valve allowing air to bleed from the tank.
After all of the air has bled from the tank, close the drain
valve to prevent debris buildup in the valve. (B)
When draining the tank, always use ear and eye protection. Drain the tank in a
suitable location; condensation will be present in most cases of draining.
Water that remains in the tank during storage will corrode and weaken the air
tank which could cause the tank to rupture. To avoid serious injury, be sure to
drain the tank after each use or daily.

OPERATING PROCEDURES

(Figure 4)
15 - ENG
C
A
E
B

Publicité

Table des Matières
loading

Table des Matières