Zyxel PLA-401 Serie Guide De Démarrage Rapide page 7

3. Press the ENCRYPT buttons at the rear of your powerline devices for
1~2 seconds.
PRESS
2 SEC.
4. While the devices are connecting, the power (
( ) lights blink. Also several times all lights blink at the same time
and the HomePlug (
5. Wait for about one minute while your powerline devices connect. The
power ( ) light is steady when the ENCRYPT process times out, the
HomePlug (
If the power (
pressed the ENCRYPT button for too long. Try again,
pressing the ENCRYPT button for 1~2 seconds.
If the HomePlug (
not light up, the powerline devices are not connected.
Repeat steps
see the User's Guide for more suggestions.
A
WITHIN
120 SEC.
) light shows red.
) light is steady if you have a successful connection.
) light does not blink, you have probably
) lights on both powerline devices do
2 and 3 in this section. If that doesn't work,
ENGLISH
B
C
PRESS
2 SEC.
) and HomePlug
7