Helpful Tips And Suggestions; Storing Your Engine; Maintenance Schedule - LCT STORMFORCE 136cc Serie Manuel D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Helpful Tips & Suggestions

STORING YOUR ENGINE

Storage Preparation
Proper storage preparation keeps your engine trouble-free and clean. The following steps will assist in keeping rust and corrosion from
impairing your engine's function and appearance, and will make the engine easier to start when using again.
Cleaning
If the engine has been running, allow it to cool for at least half an hour before cleaning. Clean all exterior surfaces and apply a light film
of spray penetrating lubricant.
• Do not spay water directly into the exhaust ports or into heat shield openings. Water that passes through these areas can cause
damage to the engine. Use a rag to wipe down heat shield if cleaning is required.
• Water contacting a hot engine can cause damage. If the engine has been running, allow it to cool for at least half an hour before washing.
Adding a Fuel Stabilizer to Extend Fuel Storage Life
• NOTICE
Fuel stabilizer is recommended for long term storage.
1. Turn the red fuel knob to the OFF position while engine is running and allow the engine to run until it stops. Turn engine OFF when
it begins surging to avoid engine damage.
2. Add fuel stabilizer, following the manufacturer's instructions.
3. Turn the red fuel knob to the ON position after adding fuel stabilizer.
4. Re-start engine.
5. Run the engine outdoors for 1 minute to be sure that treated gasoline has replaced the untreated gasoline in the carburetor.
6. Slow the engine to an idle speed.
7. Repeat step 1 above.

MAINTENANCE SCHEDULE

Normal Operating Conditions (less than 40 hrs. per year)
Engine Oil Level
Engine Oil
Spark Plug*
Cylinder/Head Fins
Oil Leaks
Bolts
Fuel Hose Clamps
* Spark plug gap to be set to 0.027 - 0.030 inches.
Extreme Operating Conditions (greater than 40 hrs. per year)
Engine Oil Level
Engine Oil
Spark Plug*
Cylinder/Head Fins
Oil Leaks
Bolts
Fuel Hose Clamps
* Spark plug gap to be set to 0.027 - 0.030 inches.
rev. 08/31/12
EACH
FIRST
EVERY
USE
MONTH
6 MONTHS
Check
Replace
Replace
Clean
Check
Check
Check
EACH
EVERY 40 HOURS
USE
Check
Drain and Replace
Replace
Check
Clean
Check
Check
Check
Liquid Combustion Technology, LLC GenII 136cc / 179cc / 208cc / 254cc / 291cc / 414cc Series Snow Engine Manual 11
ONCE
A YEAR
Replace
Clean
CAUTION
Following proper maintenance is critical
under extreme operating conditions.

Publicité

Table des Matières
loading

Table des Matières