Before Machine Start-Up; Brush Or Pad-Holder Installation; Squeegee Installation - Nilfisk Alto SCRUBTEC 343B Manuel D'utilisation

BEFORE MACHINE START-UP

Brush or pad-holder installation

NOTE
Use either the brush (54) or the pad-holder (55) according to the type of fl oor to be cleaned.
1. Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2. Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3. Place the brush (54) or the pad-holder (55) under the deck.
4. Lower the deck (10) by using the handlebar (2).
5. Engage the brush/pad-holder by pressing the brush/pad switch (65) for a few seconds. If the procedure is diffi cult, manually
turn the brush/pad-holder counter-clockwise (58).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles

Squeegee installation

6. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank fi lling
7. Open the recovery water tank cover (41) and engage the support rod (59).
8. Use the fi ller neck (45) to fi ll the tank (32) with a solution suitable for the work to be performed. Do not fi ll the solution tank
completely, leave a few centimetres from the edge. Always follow the dilution instructions on the label of the chemical product
used to prepare the solution. The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
Adjustments
9. Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
909 6313 000(4)2009-11 A
USER MANUAL
Midlite Grit 180 Midgrit 240
SCRUBTEC 343B
ENGLISH
Prolite Union Mix
13