jbc Advanced Serie Mode D'emploi page 8

ENGLISH
Electric desoldering pump
MS 9014 Ref.9014000
Air pressure desoldering system
MS 9015 Ref.9015000
Desoldering air filter
Spare filters
Ref.0005966
Heating element
Ref.5650010
DR 8500
desoldering iron stand
Ref.0788500
DR 5650
desoldering iron
Ref.5650000
Tool connector
Desoldering iron
vacuum inlet
DR 5650 DESOLDERING IRON
DI 2860 station allows you to connect the
DR 5650 desoldering iron Ref. 5650000
by adding
desoldering pump Ref. 9014000 or the MS
9015 air pressure desoldering system Ref.
9015000.
For the desoldering iron to work properly,
the following components are required: the
control unit, the desoldering iron, a
desoldering pump module and the DR
8500 stand.
These articles are not included with the
station.
The desoldering iron is connected to the
station following the below procedure:
Connect the cable connection from the
desoldering iron to the plug in the DR 8500
desoldering iron stand, connect the
vacuum hose to the vacuum inlet of the
desoldering pump module.
The cable connection of the desoldering
iron stand must be connected to the tool
connector at the back of the station and
the cable connection of the desoldering
pump must be connected to the
desoldering pump connector.
6
Desoldering pump
connector
the MS 9014 electric