Recommendations For Use - jbc Advanced Serie Mode D'emploi

ENGLISH
DI 2860 digital control unit
- DI 2860 230V
- DI 2860 120V
- DI 2860 100V
You can connect this unit to all the tools of our
Advanced series
corresponding stand, including the DR 5650
desoldering iron by adding the electric
desoldering pump MS 9014 Ref. 9014000 or the
air pressure desoldering system MS 9015 Ref.
9015000.
The station's components:
DI 2860 230V Ref. 2860200
- DI 2860 230V control unit
- Connection cable to mains
- Instructions manual
DI 2860 120V Ref. 2860100
- DI 2860 120V control unit
- Connection cable to mains
- Instructions manual
DI 2860 100V Ref. 2860109
- DI 2860 100V control unit
- Connection cable to mains
- Instructions manual
Kit DI 2860 -2245 230V Ref.2860230
- DI 2860 230V control unit
- 2245 handpiece
- AD 8245 stand
- 2245-003 cartridge
Kit DI 2860 -2210 230V Ref.2860231
- DI 2860 230V control unit
- 2210 handpiece
- AD 8210 stand
- 2210-001 cartridge
Speak to your distributor for more kits.
Ref. 2860200
Ref. 2860100
Ref. 2860109
but always using
Ref. 0269300
Ref. 0269320
Ref. 0269320
Ref. 2860200
Ref. 2245000
Ref. 0788245
Ref. 2245003
Ref. 2860200
Ref. 2210000
Ref. 0788210
Ref. 2210001
Technical specifications
- Temperature selection from 90 to 450°C or
190 to 840°F (±5%).
- Power: 75W.
- Safety transformer, mains separator and
double isolation, with integrated temperature
its
protection fuse.
- DI 2860 230V control unit
Input: 230V 50Hz. Output: 24V.
- DI 2860 120V control unit
Input: 120V 60Hz. Output: 24V.
- DI 2860 100V control unit
Input: 100V±10% 50/60Hz. Output: 24V.
- Total weight of unit: 2,5Kg (6,25lbs).
- ESD protected housing "skin effect".
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- RoHS compliant.
- Equipotential connector and the tool tip are
connected to station mains ground supply for
ESD protection.
This product should not be thrown in the
garbadge.

RECOMMENDATIONS FOR USE

For soldering
- Preferably select a temperature below
350°C (662ºF). Excess temperature reduce
tip life.
- The tip must be well tinned for good heat
conduction.
Safety measures
- Place the tool back on its stand in order to
let it cool down before you store it.
2
Ref. 2860200
Ref. 2860100
Ref. 2860109
5 11
-10 Ohms/