Regalo 1185 Guide D'utilisation page 9

STEP 4
When you are satisfied with the general placement of your gate, fully tighten
the threaded spindle rods attached to the lower corners of the gate by further
rotating the adjustment wheels.
Continue by tightening the upper threaded spindle rods. As you tighten the
upper threaded spindle rods, you will notice the gap between the door frame
and the door begin to narrow.
In order for the gate to function properly, tighten the upper threaded spindle
rods completely without removing the plastic lock spacer. Then, pull the thumb
lock back to remove the plastic lock spacer. This will ensure proper spacing
between the door and frame.
DOOR
THUMB LOCK
PLASTIC LOCK SPACER
FRAME
NOTE: There should be equal spacing among each of the (4) threaded
spindle rods. Make the appropriate adjustment to ensure you have installed
your gate safely.
English 9