Setting The Double Regulator - NOSTALGIA PRODUCTS Kegorator KRS2100 Serie Manuel D'instructions

SETTING THE DOUBLE REGULATOR

The Double Regulator connects the CO 2 Tank to the CO 2 Line, while measuring
PSI (pounds per square inch) and the volume of CO 2 in the tank. Set the
Output Pressure Gauge between 8-12 PSI for a nice, frothy head.
Pressure Dial: Adjusts
the output pressure
(loosen set screw with
included Allen Wrench)
Tank Pressure Gauge:
Measures PSI of
CO 2 in CO 2 Tank
Pressure Relief Valve
(PRV): Allows gas to
flow through Regulator
to obtain an accurate
pressure reading.
1. Close the Shut Off Valve on the Double Regulator, and open the CO 2 Tank valve completely.
2. Unlock the Pressure Dial set screw using the included Allen Wrench. Turn the dial
all the way to the negative, then pull the Pressure Relief Valve (PRV) to ensure an
accurate reading. Then very slowly turn the Pressure Dial clockwise until the desired
pressure is shown on the Output Pressure Gauge (8-12 PSI is recommended).
• Turning clockwise will increase the output pressure (higher PSI)
• Turning counter-clockwise will decrease the output pressure (lower PSI).
3. Once desired pressure is reached, tighten the Pressure Dial set screw
using the included Allen Wrench. Once again, pull the PRV to assure
the correct setting. If necessary, readjust your settings.
4. Next, open the CO 2 Shut Off Valve on the Double Regulator to allow gas to
flow from the Double Regulator to the Keg Coupler. You will hear the keg
pressurizing. The output needle will drop momentarily until the pressure
has equalized. Then the needle will return to the point you set it at.
5. Re-check the output pressure on the Double Regulator, and if necessary
re-adjust starting at step #1 until the desired pressure is shown.
Output Pressure Gauge:
CO 2 Shut Off Valve:
(shown in open position)
Connects to
CO 2 Line
Measures PSI of CO 2
outflow from CO2 Tank
to Keg (0-60 PSI)
Connects to
CO 2 Tank
12