Programmable Auto Mode; Auto Mode Baseline Speed - Bullgenius EC Manuel D'utilisation

11 - MANUAL MODE
· MANUAL MODE allows you to keep your fan at a constant speed level, regardless of the current room
temperature.
· MANUAL MODE is indicated with the HAND icon in the top center section of the screen.
· To select your desired speed level, press the UP or DOWN arrow buttons on the controller.
· You can select between 6 speed levels, which correspond to the following percentages from the maximum
fan motor output:
· Level 0 corresponds to the output of 0% from the maximum speed
· Level I corresponds to the output of 15% from the maximum speed
· Level 2 corresponds to the output of 32% from the maximum speed
· Level 3 corresponds to the output of 50% from the maximum speed
· Level 4 corresponds to the output of 67% from the maximum speed
· Level 5 corresponds to the output of 83% from the maximum speed
· Level 6 corresponds to the output of 100% from the maximum speed
·The selected speed level is indicated on the controller's screen by the rotating impeller icon and the
number between 0-6.

12 - PROGRAMMABLE AUTO MODE

· AUTO MODE allows the controller to automatically adjust the speed of the connected fans to maintain your
pre-determined target temperature (based off of the temperature reading of the thermal probe).
To set up AUTO MODE ensure that the AUTO icon is displayed in the center of the top row of the controller's
screen, If you see the HAND icon instead, press and hold the MODE button for 3 seconds until the icon
switches to AUTO.
Use the UP and DOWN arrows to select the desired temperature. This temperature represents the level
that you want to maintain in your ventilated space. The desired temperature can be selected from 0°C(32°F)
up to 60°C(140°F).

13 - AUTO MODE BASELINE SPEED

· BASELINE (DEFAULT) speed level is the speed level maintained by the controller when your desired
temperature has been reached.
· Select the BASELINE speed level by pressing the MODE button once again when AUTO MODE is already
activated. The number displayed under the spinning propeller icon will start blinking, allowing you to select
a value from 0 to 6.
· In applications which require moving air even when your target temperature is reached, we recommend the
BASELINE speed be set at level 1-3, so that the fan maintains low to medium airflow while the temperature
is already at your desired level.
· If your application requires the fan to be turned off when your target temperature has been reached, the
BASELINE speed must be set at level 0. This effectively means that you want the fan to be blowing only when
the temperature in your ventilated space exceeds your target level.
17
EN