Powering The Controller; Celsius/Fahrenheit Scale Selection; Night Mode; Lock Buttons - Bullgenius EC Manuel D'utilisation

EN

6 - POWERING THE CONTROLLER

· This speed controller receives power through its connection to the fan.
· Once the thermal probe and at least one EC fan is connected to the
controller, the POWER button will illuminate on the screen.

7 - CELSIUS/FAHRENHEIT SCALE SELECTION

· When the controller is powered off (and connected to the fan), press
and hold the MODE button for 3 seconds. Once the temperature
appears on the screen, use the UP and DOWN arrows to select Celsius
or Fahrenheit. Press the POWER button to save your preference.

8 - NIGHT MODE

· When the controller is powered ON, the screen light can be turned
off by pressing the MODE button and UP arrow button simultaneously.
The light will turn back on once any button is pressed.
9 - LOCK CONTROLLER BUTTONS
· To prevent any changes to your settings, you may lock the
controller. You can LOCK and UNLOCK the controller by holding
the UP and DOWN arrow buttons simultaneously. The LOCK icon will
flash on the screen when the controller is in the locked state.
10 - MANUAL/AUTO MODE
· To select the smart controller's operating mode, press and hold
the MODE button for 3 seconds. In AUTO mode you will see the
AUTO icon displayed in the top central section of the display. In
MANUAL mode, you will see the HAND icon displayed in the top central
section of the display.
16