Franke PEAK PULL DOWN FFPD5550 Manuel D'installation page 5

ATTENTION: Base-O-Ring (2) should be
sitting between the countertop and faucet
base.
DO NOT use putty or other sealant at this
location.
NOTES: Solid surface installation: The
countertop mounting surface needs to be
flat and free of debris; otherwise the faucet
may not sit properly and could leak.
6. Install the mounting hardware to the
mounting shank of the Faucet Base (1)
underneath the mounting surface in the
following order: Rubber Washer (4), Plastic
Flange (5) and Fixing Plate (6) (fig. 2B).
7. Secure the faucet by tightening the
Fixing Nut (7) onto the mounting shank
of the Faucet Base (1) and tightening the
screws in Fixing Nut (7) (fig. 2B).
8. Connect the Flexible Supply Hoses (8)
to the water supply in the home (fig. 2C).
2C
8
9. Remove the Aerator (9) using the
Aerator Key (10) (fig. 2D).
10. Turn on water, flush the faucet and
Aerator (9) to remove any debris and
check for leaks (fig. 2E).
11. Reinstall the Aerator (9) and ensure
everything is functioning properly.
2D
9
10
8
– 5 –
2E
9
EN