Chore-Time W1000C1-CT Manuel D'utilisation page 8

Mount the Direct Drive Cable Winch using 4 x M12 or 1/2"High Tensile (Grade
8.8) bolts and nuts to secure the winch in place as shown below.
Ensure spring washers are used and a tightening torque of 29-33 ft/lb.
Set up the winch cable as shown below. You should have at least one turn of cable on the drum in each direction before
the load is applied. Clamp the cable firmly beneath the bolt head and washer. Note: The manual crank coupling can be
used during set up to assist cable wrapping and other adjustment (refer page 13). Guiding pulleys may need to be installed
to ensure correct tracking of the cable.
Ensure at least 10ft
of clear cable in
this direction
Mounting plate
(not supplied)
MOUNTING
8
Ensure at least 10ft
of clear cable in
this direction