Kimberly-Clark PROFESSIONAL ICON Guide Utilisateur page 8

Cage Installation (continued)
1. Remove the 6 white plastic
thumb screws on top of the
trash can unit to prepare to
install the towel dispenser. Set
thumb screws aside.
2. Use a flathead screwdriver to
remove the roll holding arms (2)
by pushing on the tab shown
in frame 2.
3. Locate 6 screws on the inside
of the dispenser assembly for
removal. The cover should be
kept off in these steps. Refer to
the Cover Removal section.
4. Remove screws and set aside.
5. Remove housing from the
cage. Set housing aside.
6. Fit in the paper towel back
housing of the dispenser into
the trash can unit. Check to
make certain that the unit
is level.
1.
3.
5.
2.
4.
PH1
6.