Cover Removal - Kimberly-Clark PROFESSIONAL ICON Guide Utilisateur

See Module Installation Manual for next steps to install.
Dispenser Access
1. To unlock the dispenser, insert
key into lock and rotate the key
a quarter turn towards the wall.
Gently pull the cover forward.
2. Support the cover while
opening.

Cover Removal

Remove dispenser cover before
installing the cage. Refer to
Dispenser Access section
for instructions to unlock
the dispenser.
1. Remove the cover by closing
it about halfway. Align bottom
edge of cover with vertical
alignment line. The key
feature on the inside of the
cover should line up with it's
corresponding slot on the
dispenser body, allowing the
cover to be flexed off.
2. Remove the cover.
(4) 2,5"
Cage Installation
Calibre 8
Enclosed**
(4) 2.5"
8 Gauge
(x4)
1.
1.
(4) 2,0"
Calibre 8
(4) 2.0"
8 Gauge
(x4) 2" 8 Guage (x4) 2.5" 8 Guage
2.
2.
(2) 2 x 4"
(2) 1 x 4"
(4) 2,5"
5/8"
Calibre 8
When installing the dispenser
ensure to follow all appropriate
safety precautions and wear proper
safety equipment including gloves.
Note: This unit is for an install with
(4) 2.5"
studs on 16 inch centers or less.
8 Gauge
** For push buttons and other
(4) 2,0"
Calibre 8
available parts, contact your
sales representative.
(4) 2
8 Ga