Audio Output - Panasonic DoubleFeature OmniVision VHS PV-D4743S-K Manuel D'utilisation

Settings for DVD Operation (continued)

Audio Output

Select the digital output to be output from the optical
digital audio output connector of DECK.
1 Press ACTION *
to display DVD MAIN MENU.
2
DVD MAIN MENU
DISC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 L e t t e r b o x
P A R E N T A L L O C K : L E V E L 8
SELECT :
SET : SET
END : ACTION
3
AUDIO OUTPUT
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
SELECT :
SET : SET
END : ACTION
I I I I I "LPCM (DVD)" selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM of
48 kHz/20 bit/24 bit or more, digital audio
converted to 44.1 kHz/16 bit or 48 kHz/16 bit is
output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright protection.)
I I I I I "Dolby Digital" selections
Bitstream: Dolby Digital bitstream (1 ch - 5.1 ch) is
output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a built-in Dolby Digital decoder.
I I I I I "dts" selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a built-in DTS decoder.
I I I I I "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory preset)
ON: For dynamic sound even at low volume, this is
useful for late-night listening. [Dolby Digital
DVDs only].
4
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit.
52
PV-D4743S-K P36-56 (030223) RAM.p65
Type of amplifier
to be connected
Press
No amplifier is connected
to select
AV amplifier (with digital
"AUDIO OUTPUT,"
audio input connector)
and without Dolby Digital/DTS
decoder
press SET
AV amplifier including
to display screen.
Dolby Digital decoder
AV amplifier including
Press
Dolby Digital/DTS decoder
to select an item,
• Make settings according to amplifier
and
connected to optical audio output as shown
press SET
in above table.
repeatedly for
output. (See below.)
*1 When connecting an amplifier (with an
optical digital input connector) which does
not contain the Dolby Digital or DTS
decoder, be sure to select "PCM".
If "Bitstream" is selected, starting DVD play
may cause such a high level of noise as to
be harmful to your ears and damage the
speakers.
*2 When a DTS decoder is connected, please
select "Bitstream" in "dts".
52
Ready Checklist
DECK is in DVD mode, press DVD.
Recommended setting
Dolby
LPCM
Digital
( DV D )
PCM*
P C M
Bitstream
P C M
Bitstream
P C M
2003/03/14, 10:34
D T S
1
1
PCM*
P C M
2
*
Bitstream