How To Use - Black & Decker CTO6305C Mode D'emploi

How to Use

This product is for household use only.
GETTING ST RTED
• Remove packing materials and any stickers. Peel off clear protective film from control
panel.
• Wash all parts as instructed in C RE nD CLE nIng.
• Select a location for the unit. Leave some space between the back of the unit and
your wall to allow heat to flow without damaging cabinet and walls.
• Insert crumb tray underneath the bottom heating elements.
• Untie the cord and unwind it.
• Plug unit into electrical outlet. 0 00 shows on the digital
display (C).
Important: During the first few minutes of use, you may
notice smoke and a slight odor. This is normal and is not a
cause for concern.
C
HELPFUL INFORM TION BOUT YOUR OVEN
• You can change the temperature from ˚F to ˚C by pressing the ▲ and ▼ buttons
simultaneously.
• For your convenience, the unit always remembers the last selected setting unless
unplugged. You can change this setting before the oven begins preheating or once it
has reached the preset temperature and time.
• You cannot change the temperature or time during the preheat cycle. Once the set
temperature is reached, you can then change the temperature or time at any time.
5
C UTION
THIS OVEN GETS HOT.
THIS OVEN GETS HOT. WHEN
WHEN IN USE, LW YS USE OVEN
IN USE, ALWAYS USE OVEN
MITTS OR POT HOLDERS WHEN
MITTS OR POT HOLDERS
TOUCHING NY OUTER OR INNER
WHEN TOUCHING ANY OUTER
SURF CE OF THE OVEN.
OR INNER SURFACE OF THE
OVEN
• If using convection bake, remember to lower the suggested temperature of a recipe or
package by 25˚F.
Caution: Unit gets hot. NEVER touch outer surfaces, including the glass door. lways
use oven mitt or pot holder.
SLIDE R Ck POSITIONS
There are 4 possible positions for the slide racks. There is an upper and a lower slot;
the rack can also be inverted for 2 additional positions (D).
Position 1
Use lower slots
along oven walls.
Insert rack using a
rack-down position.
Position 3
Use upper slots
along oven walls.
Insert rack using a
rack-down position.
D
Position 2
Use lower slots
along oven walls.
Insert rack using a
rack-up position.
Position 4
Use upper slots
along oven walls.
Insert rack using a
rack-up position.
6