Troubleshooting - EGO POWER+ SNT2110 Guide D'utilisation

TROUBLESHOOTING

WARNING:
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper.
PROBLEM
Side rails are not in
position.
Snow blower is not starting.
The motor is on but the
auger does not turn.
After passing, the snow
blower leaves a layer of
snow on the ground.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC
Always remove the battery pack(s) when servicing or transporting
CAUSE
◾
Knobs on the side rails
and/or handle-clamp
lever are not secured.
◾
Battery charge is low.
◾
The steel auger is
frozen by snow or ice.
◾
The battery is
overteated. The LED
indicator on the
battery flashes orange
or shines red. (see the
section "BATTERY
HIGH-TEMPERATURE
PROTECTION" in this
manual.
◾
Safety Button is not
depressed.
◾
The drive belt is worn
or broken.
◾
The scraper bar is
worn.
SOLUTION
◾
Make sure that knobs on the side
rails are fully tightened and the
handle-clamp levers are fully
closed.
◾
Charge the battery.
◾
Remove the battery pack(s)
firstly, use the a clean-out tool
to clear the snow or ice that
obstruct on the auger. Restart the
snow blower.
◾
Remove the overheated battery
from the snow blower and wait
until the battery pack cools down
to approximately 152°F (67°C),
then reinstall the battery and
restart the snow blower.
◾
Press the safety button and, with
the button depressed, pull the
bail switch upward to meet the
handle.
◾
Replace the drive belt following
the section "REPLACING THE
DRIVE BELT" in this manual.
◾
Replace the scraper following
the section "REPLACING THE
SCRAPER BAR" in this manual.
31