Eliminating Blockage In Tilt Position; Eliminating Blockage In Turn Position; Eliminating Faults; Procedure Following Defect/Power Failure - GEZE F 1200+ Mode D'emploi Original

Faults
9.2. 1

Eliminating blockage in tilt position

When the leaf is moving from the tilt position towards CLOSE and there are objects trapped in the window, the
drive stops and moves in the opposite direction.
à The LED status display indicates the blockage by a flashing signal (yellow).
Eliminate the blockage
Eliminate the obstacle in the closing path.
X
Press the tilt close
X
The leaf moves from the tilt position towards CLOSE.
9.2.2

Eliminating blockage in turn position

If the user wishes to close a leaf again in turn position, the leaf is sometimes not pressed sufficiently into the
closed position. The drive tries to lock the leaf and recognises (on account of the operating error protection of
the fitting) that the window is not closed properly and thus cannot be locked.
à The LED status display indicates by a flashing signal (yellow) that the window cannot be locked properly.
The fault display goes out after 3x flashing if the fault was caused by a window blockage and repeated
activation is possible.
Eliminate the blockage
If necessary, eliminate the obstacle in the closing path.
X
Press the leaf completely closed again.
X
Press the turn position key.
X
The leaf is locked.
9.3

Eliminating faults

The following work may only be carried out by instructed operators, experts and by service technicians authorised
by GEZE.
If faults have occurred the LED status display lights up steady yellow until the fault has been eliminated by an
authorised service technician.
Do not eliminate faults yourself.
X
Carry out emergency locking/opening if necessary (see chapter 9.4 "Procedure following defect/power failure").
X
Put the drive system out of operation (see chapter 10 "Decommissioning").
X
Secure the window unit and drive system against triggering (e.g. by means of a sign reading "Out of operation").
X
9.4

Procedure following defect/power failure

The following work may only be carried out by instructed operators, experts and by service technicians authorised
by GEZE.
In the event of a defect or faulty behaviour of the drive system, mechanical damage or power failure, it can be
necessary to emergency-open or emergency-close the leaf.
In the event of power failure:
X
à Emergency-open the leaf (see chapter 9.4.2 "Emergency-opening of the window").
à Emergency-close the leaf (see chapter 9.4.1 "Emergency-locking of the window").
In the event of other causes (defect, faulty behaviour, mechanical damage):
X
Contact GEZE Service or service technicians authorised by GEZE for elimination of the fault.
CAUTION!
Injuries caused by impact, crushing and pinching!
Make sure there are no body parts (hands, fingers) in the closing area of the leaf.
X
NOTE!
Damage to the drive by unsuitable tools!
Never use a cordless screwdriver or similar tool for the spindle movement.
X
26
key again.
F 1200+